Replacing Keypad Batteries; Replacing The Lamp And Filter - Christie Roadster S+12K User Manual

4.3 Replacing
Keypad
Batteries
4.4 Replacing the
Lamp and Filter
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
Proper face shield and protective gloves are required if the lamp
module is removed from the projector.
The IR Remote Keypad uses two AA size, 1.5V batteries (preferably alkaline). To
install new batteries:
1) Open the battery
compartment at the
backside of the keypad by
placing your thumb in the
oval depression and sliding
the cover out about ½ inch.
See Figure 4.1. Remove the
old batteries and properly
discard. Wait a minute or
two.
2) Place the new batteries in the compartment, orienting the positive/negative of each
battery according to the labels in the compartment. When the batteries are in place,
replace the cover by placing the cover ½ inch from its closed position and slide it into
place. Do not force the cover.
NOTE: Always wait a minute or two when replacing batteries so that the internal
electronics discharge and can recognize the change.
For this procedure you will need the appropriate Roadster S+12K/HD12K, Roadster
S+16K/Mirage S+14K or Roadster S+20K/HD18K/Mirage HD12/HD18 Lamp and
Filter Replacement Kit manufactured by Christie Digital Systems. See Table 4.2
below.
WARNING
Figure 4.1. Replacing Batteries
Maintenance
4-5