Christie Roadster S+12K User Manual page 50

Operation
3-8
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Input 2
Press to display from the DVI source connected to
Input 2
pressing this key will change the PIP source.
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
enabled, pressing this key will change the PIP source.
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
enabled, pressing this key will change the PIP source.
Input 5
Input 5
Press to display from the
Input 5
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI module is installed, the second input
(B) is considered
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module, press
. This switches to either
Input 5
Module inputs (A or B) was last used. Press
Dual SD/HD-SDI Module input.
Input 6
Input 6
Press to display from the
Input 6
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI module is installed, the second input
(B) is considered
press
INPUT 6
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module, press
. This switches to either
Input 6
SD/HD-SDI Module inputs (A or B) was last used. Press
from the other Dual SD/HD-SDI Module input.
Input
Input
NOTE: Available on "brick" rental staging keypad only.
Enter
Input n
selecting which source to display. Six source locations are identified with input
numbers on the projector's input panel. The last two, 7 and 8, require the Dual
SD/HD-SDI Module installed in either of the option slots.
INPUT 5
Press
INPUT 7. INPUT 5
, press
INPUT 5
INPUT 5
INPUT 6
. If you are using the built-in keypad or the remote keypad,
INPUT 8
to access as follows:
INPUT 8
, press
INPUT 6
INPUT 6
(where n = 1, 2, 3, 4, 5, 6, 7 or 8) as an alternative method for
INPUT 2
INPUT 4
interface module installed in the Option 1. If
to access as follows:
INPUT 7
again. This switches to
Input 5
or , depending on which of the Dual
INPUT 7
again to display from the other
Input 5
interface module installed in the Option 2. If
again. This switches to
Input 6
or , depending on which of the Dual
INPUT 8
Input 6
Roadster & Mirage S+/HD User Manual
INPUT 1.
. If PIP is enabled,
. If PIP is
INPUT 3
. If PIP is
.
INPUT 7
.
INPUT 8
again to display
020-100002-04 Rev. 1 (12-2008)