Christie Roadster S+12K User Manual page 12

Installation & Setup
STEP 4 
STEP 5 
STEP 6 
2-2
Line cord replacement must be performed by qualified service
personnel in accordance with specific national electrical safety
regulations. For details, refer to the Service Manual and contact
• The Roadster S+12K/HD12K and the Mirage HD12 require 200-240 VAC, 50-
60 Hz, 12 amps @ 200 VAC.
• The Roadster S+16K and the Mirage S+14K require 200-240 VAC, 50-60 Hz,
16 amps @ 200 VAC.
• The Roadster S+20K/HD18K/Mirage HD18 require 200-240 VAC, 50-60 Hz,
24 amps @ 200 VAC.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. Refer to Section 6.
Turn On the Projector and Lamp
1. On the projector, turn the power
breaker/switch on. The LCD Status
Display Window displays the
initializing window for 15 seconds,
and then indicates
POWER OFF
(Figure 2.1).
2. Using the keypad, do one of the
following:
• Press and hold
toggle the lamp on.
• Press and release
immediately by
• Press to toggle from the
off state.
The LCD Status Display Window
will display Powering Up and
then, Power On (Figure 2.1) while
the two-digit Status/Error Code
Window will display ON.
Select a Source
Using either keypad, press
the image for the source you connected in Step 2. The display will resize as needed
and produce largest possible image for the type of source present.
Optimize the Display
Press Aut o on the built-in keypad (or
Set up
automated process in which the projector optimizes critical display parameters such as
size, position, pixel tracking, etc., for the current source. Auto Setup can save time in
perfecting a display and you can modify the adjustments later as desired. See Section 3.
WARNING
your dealer.
WARNING
briefly to
followed
.
Figure 2.1. Turning on the projector
, ,
,
Input 1 Input 2 Input 3 Input 4
on the remote keypad) to initiate an
, , or
to select and display
Input 5 Input 6
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)