Power Connection - Christie Roadster S+12K User Manual

2.7 Power
Connection
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
To isolate just RS422 communications, select "RS232 and Ethernet Joined". In
Figure 2.37, only projector #3 will respond to the RS422 controller. To isolate just
Ethernet communications, select "RS232 and RS422 Joined"—only projector #1 will
respond via Ethernet.
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards.
Plug the projector's high-current line cord into the line input socket located in the
lower right corner of the rear panel of the projector, then plug the 3-pronged end of
the line cord into a grounded AC outlet. Ensure the socket outlet is installed near the
equipment and is easily accessible. Input voltage to all Roadster and Mirage models
must be capable of 200 –240 VAC. Use the proper power source and the high-
current rated line cord provided. See Section 6, Specifications for all power
requirements.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range.
Caution for Shutdowns: Once the projector is turned off (
cooling fans will continue to run for approximately five minutes to ensure that the
projector and lamp have sufficiently cooled, at which point the fans will
automatically shut off. To avoid thermal stress that can lead to premature lamp
failure, never unplug the line cord while the lamp cooling fans are running, and
never unplug to power down.
Figure 2.37. Joining All Networks
WARNING
Installation & Setup
), the lamp
2-27