Installation & Setup; Quick Setup - Christie Roadster S+12K User Manual

This section explains how to install and set up the projector. If you are familiar with the projector and want to quickly
set it up for temporary use, follow the Quick Setup instructions below. For a more complete setup, follow the
instructions and guides covered in the remaining subsections.
NOTE: The lens is not installed for shipping. Refer to 4.5, Replacing the Lens.
2.1

Quick Setup

STEP 1 
STEP 2 
STEP 3 
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
Installation & Setup
Follow these steps for quick setup of the projector in a standard floor mount position.
Use either the remote or built-in keypad to work with the projected image.
Position the Projector
Set the projector at the expected throw distance (projector-to-screen distance) and
vertical position. See 2.3, Projector Position and Mounting and Appendix D. Ensure
the projector is level from side-to-side (see Section 2.9, Leveling).
Connect a Source
Locate the main input panel at the rear of the projector and connector your source to
the appropriate input:
•
INPUT 1 (upper right area) – RGB input via BNC connectors.
•
INPUT 2 (left of BNCs) – digital or analog signals (DVI-I) from a computer.
•
INPUT 3 (upper middle area) – composite video.
•
INPUT 4 (upper middle area) – S-video.
•
INPUT 5 (lower area) – a factory-installed Dual SD/HD-SDI module that can
accept serial digital is included on Roadster models.
•
INPUT 6 (lower area) – for optional input modules (see Appendix F).
Connect to Power
The North American rated line cord is provided with each projector. For all
other regions, ensure that you are using a line cord, power plug and socket that
meet the appropriate rating standards.
Connect the projector's line cord to the AC receptacle (Roadster
S+20K/HD18K/Mirage HD18 have non-detachable line cords) at the lower corner on
the rear of the projector, and to proper AC—note the outlet must be near the
equipment and easily accessible. Use only the line cord provided with the projector
or a power cord of appropriate ratings that comply with regional standards. Power
requirements are shown below, with complete information in Section 6.
S e c t i o n 2
2-1