Christie Roadster S+12K User Manual page 76

Operation
3-34
Saturation submenus. It is most often needed with multiple-projector applications.
Select the color adjustment producing the best color accuracy for your application
and installation.
To configure a "User" color adjustment (gamut), use either the Color Adjustment by
X/Y or Color Saturation submenu.
NOTES: 1) "Color Temperature" defaults to 6500K until changed. All four "User"
options default to SD Video unless the user has redefined them. 2) Factory-defined
color primaries, which ensure consistent color gamut from projector-to-projector,
can be calibrated in the Service menu only. If you suspect alteration, the factory
settings can be recovered with selection of "Reset to Factory Defaults?" in the Color
Primary Settings submenu within the Service menu (password-protected).
COLOR TEMPERATURE —
to all displays. Color temperatures are expressed in degrees Kelvin (3200-9300K),
and utilize different combinations of the projector's original native color primaries to
produce a "coloration" or cast (reddish or bluish) in images—the lower the
temperature, the more reddish the cast; the higher the temperature, the more bluish
the cast. Note that the slidebar is enabled only if you have a source connected and
have selected "Color Temperature" in the adjacent "Select Color Adjustment" pull-
down list in the Advanced Image Settings menu.
The optical aperture inside the projector controls the diameter
OPTICAL APERTURE -
of the light beam passing through the system. With a fully open aperture (slidebar
default of "0"), the maximum amount of light passes through for maximum
brightness in your images. Increase the slidebar setting to reduce the aperture
diameter and maximize contrast ratio instead. Performance of aperture depends on
the lens in use.
NOTES: 1) Optical Aperture (when present) also appears in the Lamp menu. 2) If
upgrading to 1.5c software and greater in earlier versions of the Roadster S+20K,
the Optical Aperture option will be available but adjustment will have no effect since
older models do not contain the Optical Aperture assembly.
- No function.
RESERVED
Mirage S+ Series — Simulation 3D —
SETTINGS
Use the options in the Simulation 3D
menu to make the timing adjustments
necessary for realistic simulation and
3D images.
NOTE: For complete 3D application
notes, refer to the separate Using 3D
in Mirage manual provided with the
Mirage projector.
FRAME DELAY MONITOR —
results, the value should remain fairly
constant, indicating that timing of input and output frames is locked; the Frame Delay
Monitor value should stay within 5-10 lines or so of the Frame Delay setting. If a
Adjust to apply a specific and accurate color temperature
SUBMENU OF ADVANCED IMAGE
Frame Delay Monitor
1.
2.
3.
3D Stero Sync Locking
4.
3D Stero Sync Select
5. 3D Stereo Sync Delay
6. Frame Lock Enable
7.
Figure 3.17- Mirage S+ Models
For best
Simulation 3D
1047
1000
Frame Delay
128
Dark Interval
Output
Input A
1000
Locked
Reserved
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)