Christie Roadster S+12K User Manual page 29

YPbPr 
(COMPONENT VIDEO)
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
Connect the BNC input(s) first. Then connect the red, green, and blue source
SYNC
outputs to the ,
RED GREEN
sync-on-green, only the red, green, and blue connections are required. If the source
provides a composite sync output, connect it to the
the source provides separate horizontal and vertical sync outputs, connect horizontal
sync to the input labeled
SYNC
labeled See Figure 2.25, below.
VERT.
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB
signal, specify this Color Space option within the Image Settings menu. See 3.6,
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
sources–to , use the red, green and blue BNCs as described in YPbPr Signals
INPUT 1
(below)
Connect a YPbPr signal (a.k.a. component video) to
Figure 2.26.
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal,
specify this Color Space option within the Image Settings menu. See 3.6, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
. Use the appropriate digital interface option installed at
1 or 2
Figure 2.26. Connecting YPbPr
, and BNCs on the
BLUE
and connect vertical sync to
HOR/COMP,
Figure 2.25. Connecting RGB Input
Installation & Setup
panel. If the source uses
INPUT 1
input labeled
SYNC HOR/COMP
SYNC
or as shown in.
INPUT 1 INPUT 2
INPUT 5 or 6
. If
input
INPUT
.
2-19