Christie Roadster S+12K User Manual page 49

Keypad Commands 
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
Note that three keys—Power, Shutter and OSD—press key once, refer to Figure
2)
3.3 Remote Keypad.
3) Hold arrow keys down for continuous adjustment/movement in one direction. In
serial networks, pause briefly between adjustments to ensure that more distant
projectors can "keep up" with the commands.
If you press a key while the projector is still responding to the previous action,
4)
such as during power-up, the second key press may not take effect.
Specific keypad commands are explained below:
Power ON/OFF
Press and hold
press twice. Or press and release
(off) to guarantee the correct toggle (useful if you are unsure of the present state).
NOTES: 1) After powering down, the lamp cooling fan remains on for
approximately 5 minutes to cool the lamp. 2) It is a good idea to avoid turning a
projector back on until it has been off for several minutes. Hot re-strikes of the lamp
may reduce lamp life.
Test
T est
Press to scroll through the projector's internal test patterns. When a test pattern
T est
is up, use
Auto
Auto
S etup
Press Auto to initiate an automated process in which the projector optimizes critical
S etup
display parameters such as size, position, pixel tracking, etc., for the current unlocked
channel. These parameters are listed in Table 3.1. An Auto Setup can save time in
perfecting a display, and you can further modify the settings as desired.
Channel
C hannel
Press to select a specific source setup (channel) defined and stored in projector
Channel
memory. Once you enter a two-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE: Channel (
not the Display Channel List option is enabled in the Menu Preferences menu. You
can choose to use a scrollable list of channels when you press
to enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
briefly to toggle the projector on or off with a single keystroke or
followed immediately by
to scroll through the patterns without going back to the input.
Table 3.1. Auto Setup
What an "Auto Setup" Does
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
), the display will automatically change and update
) key behavior during a presentation depends on whether or
C hannel
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
, or you may prefer
Channel
Operation
(on) or
3-7