Using The Keypads - Christie Roadster S+12K User Manual

Operation
3.3 Using the
Keypads
Built-in 
TABLE 3.1 – LED Status
Display
3-4
•
LCD STATUS DISPLAY WINDOW -
system status (such as an error). During normal operation, this display indicates
Power On and includes the frequencies of the vertical and horizontal syncs. The
display also shows if the On Screen Display (OSD, or menu system) is on or off.
The LCD displays the message Power Off when the breaker is on but the lamp is
off.
Keypads / Sensors
•
WIRED REMOTE KEYPAD CONNECTOR -
the projector.
•
BUILT-IN KEYPAD -
•
INFRARED SENSORS -
projector receive infrared signals from the IR keypad for remote control of
projector functions. For proper operation, ensure these sensors are not blocked.
Using one of the following keypads typically controls the projector:
•
Built-in Keypad at the rear of the projection head
•
Remote Keypad for tethered or tether-less control (includes cable for connecting
as a wired remote)
While each of the keypads provides complete control of the projector, they differ
slightly in their arrangement of keys and in which functions can be accessed directly
with a key press rather than requiring use of the menu system. You may find one
keypad more convenient than another for your specific installation and application.
To control the
projector when
signals from a
remote keypad
cannot reach the
projector, use the
projector's built-
in keypad (Figure 3.2). Two nearby status windows provide feedback indicating
current status and activities of the projector, (see Table 3.1). Because the built-in
keypad has fewer keys than the remote keypad, certain projector functions are
accessible only through the menu system rather than via a direct key. NOTE: The
built-in keypad cannot be disabled.
LED STATUS DISPLAY:
- -
On

LC
LP
SH
# #
Displays a text message describing the current
For optional tethered remote control of
Alternative location for working with the projector.
The infrared (IR) sensors on the front and rear of the
Figure 3.2. Built-in Keypad at Projector Rear
DESCRIPTION
AC power supplied, projector Off
Projector On
Lens calibration in progress
Lamp has reached defined "Lamp Limit" refer to 3.9 Working with
the Lamp
Closed shutter
System warning or error has occured
Cooling down (Rotating Horizontal Bars)
Power to Off state or Powering up (segments spinning clockwise
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)