Unpacking The Shipping Container; Identifying Product Components - HP BL536A User's & Service Manual

Table 10 Location criteria (continued)
Criteria
Rack requirements
Rack space
requirements
Room temperature
Power source
Weight without media
Weight with media
Air quality
Humidity
Clearance

Unpacking the shipping container

Before you begin, clear a level work surface near where you will place the Autoloader.
CAUTION:
F) from the room where it was stored, allow it to acclimate to the surrounding environment for at
least 12 hours before unpacking it from the shipping container.
Unpacking the Tape Autoloader:
1. Inspect the container for shipping damage. If you notice any damage, report it to the shipping
company immediately.
2. Open the shipping container and remove the packaging foam and accessories that cover the
device.
3. Lift the device out of the carton, place it on the work surface.
CAUTION:
4. Remove any other accessories from the shipping container. Save the packaging materials for
future use.

Identifying product components

Confirm that you received the product components shown in
Definition
Do not place the Autoloader on its sides or upside down. Do not put anything on top of the
Autoloader unless the optional tabletop conversion cover is installed. The tabletop conversion
cover can support up to 15 kg (33 lb).
HP Rack 5000, 10000 Series, HP Rack System/E
1U when mounted in the optional rack rails
10-35º C (50-95º F)
AC power voltage: 100- 1 27 VAC; 200-240 VAC
Line frequency: 50-60 Hz
Place the device near an AC outlet. The AC power cord is the product's main AC disconnect
device and must be easily accessible at all times.
1 1.5 kg (25.4 lb)
13.1 kg (28.9 lb)
The device should be placed in an area with minimal sources of particulate contamination.
Avoid areas near frequently used doors and walkways, stacks of supplies that collect dust,
printers, and smoke-filled rooms.
Excessive dust and debris can damage tapes and tape drives.
20-80 percent relative humidity non-condensing
Back: Minimum of 15.4 cm (6 inches)
Front: Minimum of 30.8 cm (12 inches)
Sides: Minimum of 5.08 cm (2 inches)
If the temperature in the room where the device will be installed varies by 15º C (30º
Do not place the Autoloader on either end or its sides as this may damage it.
Product components (page
Unpacking the shipping container
22).
21