Setting The Scsi Address - HP Surestore Tape Library Model 10/588 Hardware Manual

Library storage module

Hide thumbs Also See for Surestore Tape Library Model 10/588:

Table of Contents

Setting the SCSI Address

You set the SCSI robotic address from the LSM operator panel. You might need

to get the address from your systems administrator.

Refer to

Figure 2-2

Note: You cannot set the SCSI drive addresses from the LSM operator panel.

For DLT drives, your customer representative uses the switches on the

drive to set the SCSI drive addresses, as described in the installation

manual. For 9840 drives, SCSI drive addresses are set through the drive's

front panel. This can only be done by a certified Customer Service

Engineer.

CAUTION:

During this procedure, the panel displays "Press Execute to Enter Lib

Size." This is not normally an operator function. Altering the library size

can cause initialization errors or damage the hand if the size is set

incorrectly to full size when the library has a standard door instead of an

expansion door. Instead of pressing Execute, press Menu.

and

Figure 2-3

to set the SCSI address.

Setting the SCSI Address

2-3

Table of Contents

Do you have a question about the Surestore Tape Library Model 10/588 and is the answer not in the manual?

A4845a