Setting The Scsi Address - HP Surestore Tape Library Model 6/100 Hardware Operator's Manual

Hardware Operator's Guide

Setting the SCSI Address

You set the SCSI robotic address from the LSM operator panel. You might need to
get the address from your systems administrator.
Refer to Figure 2–2 and Figure 2–3 to set the SCSI address.
Note: You cannot set the SCSI drive addresses from the LSM operator panel.
CAUTION:
During this procedure, the panel displays "Press Execute to Enter Lib
Size." This is not normally an operator function. Altering the library
size can cause initialization errors. Instead of pressing Execute,
press Menu.
Your customer representative uses the switches on the drives to set the
SCSI drive addresses, as described in the installation manual.
2–3