Checking A Reported Component - Promise Technology VTRAK E310f Product Manual

Checking a Reported Component

In this example, let us check disk array status.
1. Open the CLU.
2. Highlight Disk Array Management and press Enter.
3. Observe the status of your disk arrays.
DaId Alias
-------------------------------------------------------------------------------------------
0 DA0
1 DA1
2 DA2
At this point, you can highlight the Degraded array and press Enter to see more
information. See below.
Disk Array ID
OperationalStatus
FreeCapacity
SupportedRAIDLevels: 0 5 10 1E
Disk Array Alias
MediaPatrol
PDM
Transport
Rebuild
Predictive Data Migration
Transition
Dedicated Spare Drives in the Array
Physical Drives in the Array
Logical Drives in the Array
[Locate Disk Array]
Save Settings
Restore Settings
Return to Previous Menu
From this screen:
• Highlight Physical Drives in the Array and press Enter to identify the failed
disk drive
• Highlight Rebuild and press Enter to rebuild the array after you replace the
failed disk drive
For more information, see "Critical & Offline Disk Arrays" on page 276.
OpStatus CfgCapacity FreeCapacity
OK 75.44GB
Degraded 189.06GB
OK 73.57GB
: 1
: Degraded
: 179.68 GB
: DA1
: Enabled
: Enabled
[CTRL-A]
[CTRL-R]
257
Chapter 8: Troubleshooting
66.06GB
179.68GB
64.20GB
Physical Capacity
MaxContiguousCapacity : 11.18GB
ConfigurableCapacity
MaxContiguousCap
66.06GB
179.68GB
64.20GB
: 189.06GB
: 179.68GB