Promise Technology VTRAK E310f Product Manual page 25

6. Attach a two-hole flange to the rail, with the flange toward the back
(connector end) of the enclosure.
Install four rail adjustment screws (included) through the flange into the rail.
7. Repeat steps 4 through 6 to attach the other rail and flanges to the
enclosure.
8. Place the enclosure with mounting rails into your rack system.
9. Attach the four-hole flanges to the inside of the rack's front post, using the
attaching screws from your rack system.
10. Attach the two-hole flanges to the inside of the rack's rear post, using the
attaching screws from your rack system.
11. Square the rails in the rack.
12. Tighten the adjustment screws and the attaching screws.
Figure 2. Rack mount assembly diagram
Rack front post
Inside of post
Rail adjustment screw
Front flange
Rail attaching screw
(not included)
Rail adjustment screw
Rear flange
Rail
Plate
Rail attaching screw
(not included)
11
Chapter 2: VTrak Installation
Rack back post
Inside of post