Toshiba e-STUDIO 600 User Manual page 312

8 Troubleshooting
Error Code
2D65
2D66
2D67
2D68
2DC0
2DC1
Store to e-Filing
2A20
2A40
2A50
2A51
2B10
2B11
2B20
2B21
2B30
2B31
2B32
2B50
312 TopAccess Error Messages
Message
There are too many documents in the
folder. Failed in creating new document.
Failed to process your job. Insufficient
storage space.
FTP service is not available
File Sharing service is not available
Job canceled
Power failure occurred
Failed to acquire resource.
System fatal error.
Job canceled.
Power failure occurred.
There was no applicable job.
Job status failed.
Failed to access file.
Message size exceeded limit or maximum
size.
Insufficient disk space.
Failed to access Electronic Filing.
Failed to print Electronic Filing document.
Failed to process image.
Corrective Action
Delete the data in the local storage folder
in the equipment and retry the scan.
Delete the data in the destination folder in
the equipment and retry the scan.
Ask your administrator whether the FTP
service is configured correctly.
Ask your administrator whether the SMB
protocol is enabled.
(Job was canceled.)
Make sure that the power cable is con-
nected properly and it is inserted securely.
Resend the job.
Retry the scan.
Turn the power OFF and then back ON.
Retry the scan.
(Job was canceled.)
Make sure that the power cable is con-
nected properly and it is inserted securely.
Resend the job.
Retry the scan.
Retry the scan.
Retry the scan.
You are sending too many documents at a
time. Send your documents separately.
Delete unnecessary documents in e-Filing
and try again.
Make sure that the specified e-Filing or
folder exists. (If not, this error would not
occur.) Delete the specified e-Filing or
folder and reset them. Retry the job in
error. If the specified e-Filing or folder can-
not be deleted, contact your service repre-
sentative.
Make sure that the specified document
exists. (If not, this error would not occur.)
Delete the specified document and reset
them. Retry the job in error. If the speci-
fied document cannot be deleted, contact
your service representative.
Turn the power OFF and then back ON.
Retry the scan. If the error still occurs,
contact your service representative.