Kyocera 5035 Operation Manual page 283

Section 10 MAINTENANCE AND OPERATION INFORMATION
Document Processor
The Duplex Document Processor automatically feeds one-sided originals one by one for scanning. It also reverses two-sided originals automatically
for duplex copying and page separation copying.
Paper Feeder
Two Paper Feeders of the same type as drawer[cassette] in the main body can be added.
Capacity and the paper loading method is the same as those for the standard drawer[cassette] in the main unit.
Paper Feeder
The Paper Feeder holds up to 3,000 sheets of 11" x 8 " [A4 or B5 (B5 is for Asia-Pacific specification copiers only)] size standard paper.
1/2
Pull the Paper Feeder out towards you as far as it will go, and then load up to 1,500 sheets of paper in each rows.
Document Finisher
This unit lets you store a large volume of copies and shifts the position of each copy set for ease of sorting. It can staple finished copy sets and bind
them. It is also possible to use the Document Finisher to punch holes in them for filling purposes (optional).
Document Finisher
The Document Finisher stores a large quantity copies, and sorts multiple sets by shifting the position that each one is ejected. It is also possible to
use the Document Finisher to staple the copy sets or punch holes in them for filling purposes.
Document Finisher
The Document Finisher stores a large quantity copies, and sorts multiple sets (Sort: ON) or groups copies made from multiple originals, with all the
copies produced from an individual original grouped together in one set (Sort: OFF). It is also possible to use the Document Finisher to staple sorted
copy sets.
Built-in Finisher
The finisher stores a large quantity of copies. It can also sorts multiple copies into sets by shifting the eject position. Paginated copies can be
stapled, too.
Job Separator
When using the optional printer function, the paper eject point can be changed according to the used function, making it easier to sort paper. Copied
-paper can be ejected to the Job Separator (upper section). See "Copy eject location" in Machine default setting on page 7-49.
Hard Disk
The Hard Disk is required in order to use the following modes and functions of your copier.
• Job reservation
• Form overlay of registered forms
• Repeat copying
• Document management functions
• Using the output management functions to change the job printing order, cancel and delete print jobs, and verify content
It is also possible to register up to 1000 department ID-codes under document management.
Key Counter
The Key Counter determines the number of copies that have been made. It is useful for copier centralized management on a department or even
company level.
Document Tray
The Document Tray lets you place originals and other documents next to the machine before using them, etc. It also contains space for storing
paper clips, etc.
Printer Kit
If the Printer Kit is installed, this copier can be used as a printer.
Since the network board is equipped, this copier can also be used as a network printer, allowing access from multiple computers.
Printer/Scanner Kit
If the Printer/Scanner Kit is installed, this copier can be used as a printer or a network scanner.
Since the network board is equipped, this copier can also be used as a network printer, allowing access from multiple computers.
Fax Kit
If the Fax Kit is installed, this copier can be used as a fax. Also if the Fax Kit is used together with the optional Printer/Scanner Kit, this copier can be
used as a network fax, allowing transmission and reception by a computer.
10-11