Kyocera 5035 Operation Manual page 190

Section 7 COPIER MANAGEMENT FUNCTIONS
● Fax eject location
Perform the following procedure to set where incoming faxes will be
ejected.
NOTE
This setting will only be displayed when the optional Fax Kit and
Document Finisher (or the Built-in Finisher or Job Separator) are
installed on your copier.
1 Display the "Machine default" screen.
(See "(2) Accessing the machine default settings" on
page 7-41.)
Inch specifications
Default setting / Counter
Default setting
Copy
default
Machine Document
default Management
Metric specifications
Default setting / Counter
Default setting
Copy
default
Machine Document
default Management
2
Select "Select FAX output mode" in the settings list on the left
side of the touch panel and then touch the "Change #" key.
The "Select FAX output mode" screen will be displayed.
Inch specifications
Default setting / Counter
Machine default
Default menu
Sleep mode changing time
Low power mode chng. time
Select Copy output mode
Select FAX output mode
Select the main mode
Default setting
Metric specifications
Default setting / Counter
Machine default
Default menu
Sleep mode changing time
Low power mode chng. time
Select COPY output mode
Select FAX output mode
Select main mode
Default setting
7-50
Language Management
Bypass BOX
setting Management
Register Print
orig. size report
Language Management
Bypass Hard Disk
setting Management
Register Print
orig. size report
Setting mode
60 Minute
15 Minute
Inner tray
Inner tray
Copy mode Change #
Setting mode
60 Minute
15 Minute
Inner tray
Inner tray
Change #
COPY Mode
3 Touch the key that corresponds to the desired location.
Inch specifications
Select FAX output mode
Default setting - Machine default
Metric specifications
Select FAX output mode
End
Default setting - Machine default
Counter
check
NOTES
User
Adjustment
• The available location for ejection will differ depending upon the
optional equipment that is installed on your copier.
• If you want to quit the displayed setting without changing it, touch
the "Back" key. The touch panel will return to the screen in step 2.
End
4
Touch the "Close" key. The touch panel will return to the
Counter
check
screen in step 2.
User
Adjustment
5 Touch the "Close" key once again. The touch panel will return
to the "Default setting"screen.
6 Touch the "End" key. The touch panel will return to the
contents of the "Basic" tab.
Close
Up
Down
Close
Up
Down
Set the default fax output destination
Job
MailBox 1
separator
Inner tray
Finisher
sub tray
Set the default fax output destination.
Job
Mailbox 1
separator
Inner tray
Finisher
sub tray
Back Close
Back Close