Fitting The Window Frame Assembly; Operating And Spillage Checks; Checking The Control Settings - Valor Homeflame Dream Installation And Owner's Manual

12. FITTING THE WINDOW FRAME ASSEMBLY

1. Locate the window mounting frame and
window assembly in place.
2. Secure in place using the six screws
removed previously.

13. OPERATING AND SPILLAGE CHECKS

13.1 Checking the control settings.

Please note:
When first turned on from cold, the flames will appear predominantly blue. It is
-
normal for condensation to form on the rear of the window assembly. The
condensation will disappear after a few minutes use.
When operating the fire for the first time, some vapours may be given off which
-
could set off smoke alarms in the vicinity. These vapours are quite normal with new
appliances. They are totally harmless and will disappear after a few hours use.
- Petrus only -
After lighting the fire it is usual to have a light coating of
condensation form on the upper surface of the fascia and the area immediately
above this. This should disappear in approximately five minutes and is no cause for
concern.
1. Refit the battery if previously removed.
2. Make sure the slider button is at the off position (At topmost position).
3. Slide the button to the bottom (ignition) position. Retain in this position to ignite the
pilot. The burner should ignite at its lowest setting within 4 seconds of the pilot
igniting. Keep at this position for a further 10 seconds to allow the pilot flame to
stabilise.
© GDC Group Ltd. 2012
INSTALLER GUIDE
Figure 28. Window mounting frame and
window assembly removal
Page 30