To Remove The Glass Panel; To Remove The Window Assembly - Valor 961 Installation And Owner's Manual

INSTALLER GUIDE
17.7 To remove and fit the window mounting frame and window assembly.
When servicing the appliance it will be necessary to remove all of the window
mounting frame and the window assembly to enable the front coal, ceramic walls and
burner to be removed.
1. Remove the fascia as in section 17.4.
2. Unscrew and remove the knurled screw
connecting the slider control arm to the
burner module. Lift the slider control knob,
moving the control arm away from the
burner module.
3. Unscrew and remove the six screws that
secure the window mounting frame and
window assembly. Remove and place away
from the work area (See figure 37).

17.8 To remove the window assembly.

1. There is no need to remove the fascia.
To remove.
1. The window assembly is held in place
with two brackets that rotate around a
Figure 37. Window assembly removal
central pivot point. Push the brackets up
and clear of the window assembly (See
figure 38). Gently pull the top of the window forward and lift the window assembly
clear of its support channels (See figure
39). Place the window assembly in a safe
place away from the work area.
To fit.
1. Locate the bottom corners of the window
assembly.
2. Gently push the window assembly into
place and secure with the window clamping
brackets. The window clamping brackets
have a raised 'stop' that will prevent them
being rotated too far.
Figure 38. Window assembly removal
©
Baxi Heating U.K. Limited 2008.
Page 36