Ignition Check; Gas Supply Connection - Valor Homeflame Dream Installation And Owner's Manual

Before attempting to install, it is worth checking that the electronic ignition system
performs satisfactorily.
Fit the battery to the ignition block located below the
burner tray at the left side (See figure 10). The
positive terminal (+) is to the bottom as you insert.
Depress the slider knob as far as it will go and hold in
this position. This should close the ignition circuit and
sparks should be seen tracking from the electrode pin
to the pilot tip (See figure 11).
If there are no sparks make the following checks.
Check condition of battery and that it is correctly
fitted. -
If the above is satisfactory, check the ignition circuit
- and components - see the servicing section in this
guide.
A nut and olive are provided for an 8mm pipe inlet connection to the 'T' connector at
the bottom front of the appliance. The 'T' connector can be rotated to allow a
connection from any direction and includes a valve for isolating the gas supply and a
pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used.
Concealed Supply Pipe Connection
If a concealed connection from inside the fireplace is required then, before the
appliance is fitted into the fireplace it will be necessary to extend the supply line so
that it will project through the hole in the back of the convection box and run to the 'T'
connector at the front. The pipe run from the supply line up to the rear opening in the
convection box must be kept away from the area which will be taken by the
convection box when it is installed (See figure 6).
Note that the centre of the appliance inlet 'T' connector is 25mm above the fireplace
floor. The inlet 'T' connector should be fitted to the supply pipe at this stage.
© GDC Group Ltd. 2012
INSTALLER GUIDE

6. IGNITION CHECK

7. GAS SUPPLY CONNECTION

Page 21
Figure 10. Fitting the battery
Figure 11. Slider control