Homeflame Harmony Model; Homeflame Petrus Model - Valor Homeflame Dream Installation And Owner's Manual

14.2 Homeflame Harmony model.

14.2.1 Fitting the fascia.
1. Place the top of the fascia against the
fireplace front surface so that the two retaining
plates at the back of the fascia are directly
above the two retaining brackets on the
convector box. Keeping the lower part of the
fascia clear of the ceramic fuel effect, lower the
fascia making sure that the rear retaining plates
locate fully into the retaining brackets on the
convection box (See figure 35). The fascia
bottom is held in place with magnets. These
should be located as in figure 35.
Figure 35. Fitting the 'Homeflame Harmony' fascia
2. Supplied with the fire is a self adhesive control position label. Peel the backing from
the label and place on the fascia underneath the slider knob.

14.3 Homeflame Petrus model.

14.3.1 Fitting the fascia.
1. Supplied with the fire is a self adhesive control position label. Peel the backing from
the label and place as in figure 32.
2. Place the fascia against the fireplace front surface so that the two retaining plates
at the back of the fascia are above the two upper retaining brackets at the top of the
convection box. Lower the fascia making sure that the rear retaining plates locate fully
into the retaining brackets on the convection box (See figure 32). If the inlet pipe runs
along the front of the fireplace, the bottom of the fascia will have to be swung
forwards to clear the pipe while lowering the casting.
3. Secure the bottom of the fascia using the two machine screws and washers
supplied (See figure 33).
© GDC Group Ltd. 2012
INSTALLER GUIDE
Page 35
Fig 34 Dream casting Fig 34 Dream casting
baffle shown.
screen shown.