Battery Replacement; Regular Maintenance - Valor Homeflame Dream Installation And Owner's Manual

OWNER GUIDE
MAINTENANCE

Battery replacement.

Homeflame Dream and Homeflame Petrus
models.
To replace the battery remove the bottom front
cover casting.
Fit the new battery firmly to the connections
on the ignition block (See figure 9).
Homeflame Harmony model.
To replace the battery lift the fascia upward
and forward.
Place the fascia in a safe place away from the
gas fire.
Figure 9. Battery fitting
Fit the new battery firmly to the connections
on the ignition block (See figure 9).
To fit the fascia, place it against the fireplace front surface so that the four retaining
plates at the back of the fascia are directly above the four retaining brackets on the
convector box. Lower the fascia unit making sure that the retaining plates locate fully
into the brackets on the convector box (See figure 6). If the inlet pipe runs along the
front of the fireplace, the bottom of the fascia will have to be swung forward to clear
the pipe while lowering the fascia.

Regular maintenance.

In order to achieve and maintain high levels of personal safety and performance
efficiency, it is essential that the opening at the back of the fire and the flue are kept
clear of any form of obstruction. It is possible that deposits of mortar or soot could fall
and accumulate causing the flue to be blocked or restricted and so preventing proper
clearance of dangerous exhaust fumes.
In the United Kingdom it is the law that a landlord must have any gas appliance, flue
and pipework which is situated in a tenant's premises checked for safety at least
every twelve months by a competent person (In the UK a GAS SAFE REGISTER
engineer, Outside of the UK a CORGI or GAS SAFE REGISTER engineer).
We recommend that all gas appliances and their flues, wherever situated, are
checked annually.
When fitting replacement parts it is important that only approved parts are
used for maximum safety.
© GDC Group Ltd. 2012
Page 59