Inlet Pressure Check; Fitting The Ceramic Fuel Effect - Valor Homeflame Dream Installation And Owner's Manual

INSTALLER GUIDE

10.3 Inlet pressure check.

The appliance is pre-set to give the correct heat input at the inlet pressure shown in
section 2 of this manual. No adjustment is necessary.
1. Ensure that the appliance is switched OFF, then
fit a pressure gauge at the test point (See figure
26).
2. Check the pressure with the appliance alight
and set at maximum output.
3. After checking, turn off the appliance. Remove
the pressure gauge and replace the test point
sealing screw.
4. Test around the sealing screw for gas
soundness with a suitable leak detection fluid.
5. Homeflame Dream and Homeflame Petrus
Figure 26. Pressure test point
only - Fit the burner baffle to the front flanges of
the burner. To do this, locate the tags on the
baffle over the front flanges of the burner
and lower into position (See figure 27).
6. It is advisable at this stage to remove the
battery to avoid accidental ignition whilst

fitting the ceramic fuel effect.

Figure 27. Burner tray baffle location
11. FITTING THE CERAMIC FUEL EFFECT
The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the fitting guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of
the 'Final review' section.
© GDC Group Ltd. 2012.
Page 29