Installing To Frame & Fitting Switch- Zc Appliances - Valor 530 Direct Vent Installation Manual

11. INSTALLING TO FRAME & FITTING SWITCH– ZC APPLIANCES
1. Secure the appliance to the framing by fixing to the studding through
the bent tabs in the outer surround.
2. Refit the burner module using the 11 screws previously removed
(Figure 58).
3. a) For appliance surround switch as only active switch
•
Feed the switch wires through the switch opening in the surround.
•
Route round the back of the valve and connect to the control unit.
•
Connect the battery box to the black connection pad. See figure 59.
•
Snap fit the switch into the surround opening. The wires should hang
down from the connectors at back of the switch so that pressing the
upper arrow on the switch turns the fire up. See figure 59.
b) For active wall switch
Check with the home owner if the outer surround is to be covered by tiling
etc. If not, snap the appliance switch into the surround opening but don't connect wires to the appliance. If tiling is to be
applied, don't fit the appliance switch.
The "L" shaped terminals on the 20ft wall switch wires connect with the
burner control unit. Route the wires round the back of the valve to the wall
switch location.
The connections to the wall switch are shown in figure 60. Connect so that,
when installed in wall, pressing the upper rocker arrow increases the flame
height.
Fit the batteries supplied with the engine unit to the holder supplied with
the wall switch. Fit the wall switch plate to your switch box.
c) For active remote control without active appliance switch.
Check with the home owner if the outer surround is to be covered by tiling
etc. If not, snap the appliance switch into the surround opening but don't
connect wires to the appliance. If tiling is to be applied, don't fit the
appliance switch.
Caution! Don't connect the batteries in the remote control receiver
until the wires are connected to the burner control unit. A short circuit
could result in destruction of the electrical components.
Route the wires from the receiver round the back of the valve and connect
to the control unit.
Remove the receiver lid. Connect the battery box to the receiver wires.
Fit the four 1.5 V batteries. Replace the receiver lid.
Fit the 9V battery to the handset transmitter.
Manufactured by Miles Industries Ltd., British Columbia, Canada
Figure 58
Figure 59
Figure 60
32