Ceramic Fuel Effect Pieces And Burner Compartment Walls - Valor Homeflame Dream Installation And Owner's Manual

2. Replace in the reverse order.

Ceramic fuel effect pieces and burner compartment walls.

To gain access to the ceramic components the window assembly must be removed as
in the previous section.
It will not be possible to remove the ceramic compartment walls or ceramic front coal
for cleaning. These must be cleaned in situ.
This product uses fuel effect pieces and burner compartment walls containing
Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres.
Excessive exposure to this material may cause irritation to eyes, skin and
respiratory tract. Consequently, it is important to take care when handling these
articles to ensure that the release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the fire.
-
Should any soot accumulation become excessive, the one piece overlay coal and
ceramic fuel effect base should be removed from the fire for cleaning. It will not be
possible to remove the ceramic compartment walls or ceramic front coal for cleaning.
These must be cleaned in situ.
Cleaning should be carried out in a well ventilated area or in the open air by gently
-
brushing with the pieces held away from your face so that you avoid inhaling the dust.
We do not recommend the use of a normal domestic vacuum cleaner which may
-
blow dust back into the air.
We suggest that you remove the ceramic fuel effect pieces in the reverse order to
-
that shown in the ceramic fuel effect installer and owner guide.
Once cleaned replace the fuel effect as in ceramic fuel effect installer and owner
-
guide.
© GDC Group Ltd. 2012
OWNER GUIDE
Figure 8. Window removal
Page 57