Table of Contents
Advertisement
16.4.2 Homeflame Harmony model.
1. Carefully lift the fascia upward and forward.
2. Place the fascia in a safe place away from the gas fire.
3. To fit the fascia, place the top of the fascia against the fireplace front surface so
that the two retaining plates at the back of the fascia are directly above the two
retaining brackets on the convector box. Keeping the
lower part of the fascia clear of the ceramic fuel effect,
lower the fascia making sure that the rear retaining
plates locate fully into the retaining brackets on the
convection box (See figure 35). The fascia bottom is
held in place with magnets. These should be located
as in figure 35.
16.5 To replace the control slide unit.
1. Remove the fascia (See section 16.4).
2. Remove the knurled screw securing the control
linking arm to the burner (See figure 41).
3. Detach the slide unit by removing two screws
securing it to the convection box flange (See figure 42).
4. Replace in the reverse order.
16.6 To replace the control slide button.
1. Remove the fascia (See section 16.4).
2. Unscrew and remove the two screws securing the slide
button to the slider mechanism.
3. Remove the button, replace and fit in the reverse order.
© GDC Group Ltd. 2012
INSTALLER GUIDE
Page 40
Figure 41. Control linkage
disconnection
Figure 42. Slider
mechanism removal
Hide quick links:
Advertisement
Chapters
Table of Contents
