Setting The "Stabilizer" Function - imagistics cm3520 User Manual

10

Setting the "Stabilizer" Function

If the image is incorrect, even after the gradation levels have been adjusted, set the
"Stabilizer" function.
Reference
For details on adjusting the gradation levels, refer to "Setting the "Gradation
Adjustment" Function" on page 10-67.
There are two Stabilizer settings.
Reset and Stabilize mode
Stabilize mode
Condition
Image stabilization is basically performed based on past data up to the previous
session.
Normally, the "Stabilizer" function is set to "Stabilize".
Select "Reset and Stabilize" only if the desired effect cannot be attained with the
"Stabilize".
1
Press the [Utility] key.
2
Touch [Admin. Mode].
3
Using the keypad, type in the administrator code.
Touch [Enter].
4
Touch [Expert User Mode].
5
Touch [Stabilizer].
10-78
10.10 Specifying Expert User Mode Functions
cm3520