Table of Contents
Advertisement
3.4 Selecting Output Settings
Hole-Punching
Holes for filing copies in binders can be punched. The position of the punched holes
can be specified along the left side or along the top of the paper.
However, the holes can be punched only if all of the following conditions are met.
Finisher 9996 is installed.
Punch kit is installed.
If standard-size paper is used, the paper sizes must be as follows:
Legal L, 11 × 17 L, Letter L and Letter C (with the "2-Hole Punch" setting).
11 × 17 L and Letter C (with the "3-Hole Punch" setting).
If non-standard-size paper is used, the paper width must be:
8-1/2 or between 11 and 11-3/4 (with the "2-Hole Punch" setting)
between 11 and 11-3/4 (with the "3-Hole Punch" setting)
If non-standard-size paper is used, the paper length must be between 7-1/4 in.
and 17 in.
Copies are printed only on plain paper.
This machine must not be set to Interrupt mode.
The "Image Adjustment" function on the Application screen is not used.
cm3520
3
3-11
Advertisement
Table of Contents
