Configuring Service Group Qos Feature; Configuring Tcp Proxy - Cisco ASR 5000 Series Administration Manual

Enhanced Charging Service Configuration
Notes:
 In the Rulebase Configuration Mode, the ruledef configured for post-processing action must have been
configured for post processing in the Ruledef Configuration Mode.
 If the same ruledef is required to be a charging rule in one rulebase and a post-processing rule in another
rulebase, then two separate identical ruledefs must be defined.
 In this release, post processing with group-of-ruledefs is not supported.
 In this release, delay charging with dynamic rules is not supported, hence there cannot be dynamic post-
processing rules.

Configuring Service Group QoS Feature

To create and configure a QoS-Group-of-Ruledefs, use the following configuration:
configure
active-charging service <ecs_service_name>
qos-group-of-ruledefs <qos_group_of_ruledefs_name> [ -noconfirm ] [ description
<description> ]
add-ruledef <ruledef_name>
end
Notes:
 To configure flow action in the charging-action, in the ACS Charging Action Configuration Mode, use the
action
 To configure bandwidth limits for a flow, in the in the ACS Charging Action Configuration Mode use the
limit-for-bandwidth
 To view subscriber statistics and information on dynamic updates to charging parameters per call ID, in the Exec
Mode, use the following command:
show active-charging subscribers callid <call_id> charging-updates [ statistics ]
[ charging-action [ name <charging_action_name> ] | qos-group [ name
<qos_group_of_ruledefs_name> ] ] [ | { grep <grep_options> | more } ]

Configuring TCP Proxy

This section describes how to configure the TCP Proxy feature.
To enable and configure the TCP Proxy feature in the rulebase, use the following configuration:
configure
active-charging service <ecs_service_name>
rulebase <rulebase_name>
CLI command.
CLI command.
Cisco ASR 5x00 Enhanced Charging Services Administration Guide ▄
Configuring Enhanced Features ▀
flow
flow
107