Realpresence Group System Power - Polycom RealPresence Group Series User Manual

notifications might override the low battery notification, the low battery notification returns after the other
notifications are dismissed. The low battery notification does not display while the system is in a call.
Use a USB 2.0 port to charge the remote battery. The RealPresence Group 300, 310, and 500 systems have
two USB 2.0 ports on the back of each system, while the RealPresence Group 700 system has one USB
2.0 port on the front of the system and two USB 3.0 ports on the back of the system.
To recharge the remote control battery:
1 Pull the battery out of the end of the remote control.
2 Insert the USB plug of the battery into a USB 2.0 port such as the one on your system.
3 Wait until the status light on the battery turns green before removing it from the port.
Recharging the battery might take from 20 minutes to multiple hours.
4 Insert the charged battery into the remote control.
Recharge the Battery: RealPresence Group 300, 310, 500 and 700 Systems

RealPresence Group System Power

Powering your system on and off is a simple procedure, but it is important to perform the tasks in a certain
order. Make sure that the system is powered off before you connect devices to it. After you have connected
all of the related equipment that you intend to use, connect the power and power on the RealPresence
Group system.
It is important to note that RealPresence Group Series systems do not have what you might think of as a
power button—they have a power proximity sensor. Instead of pressing an actual button that moves, you
touch the sensor (or near the sensor) that indicates power
Polycom, Inc.
on the front of the system.
13