Stop Showing Content With People+Content Ip; Show Content From A Computer Connected To Realpresence Group System - Polycom RealPresence Group Series User Manual

To start showing content from a computer connected directly to the Touch Control:
1 Using the USB content cable, connect the computer directly to the underside of the Touch Control.
If autorun is enabled on the computer, you are prompted to run People+Content IP. If autorun is
disabled on your computer, People+Content IP shows up as an external drive, and you must navigate
to My Computer to launch it manually.
2 Launch People+Content IP.
3 In People+Content IP, open the content you want to show and click
4 To stop showing content, click

Stop Showing Content with People+Content IP

When you are done showing content, you must shut down People+Content IP.
To stop showing content:
1 If the People+Content IP toolbar is minimized, maximize it by clicking the icon in the task bar.
2 Click in People+Content IP.
3 Click Disconnect.
Show Content from a Computer Connected to RealPresence Group
System
Before you show content, check that the computer video output is configured to use one of these supported
resolutions and refresh rates. For best video quality, use refresh rates of 60 Hz or less.
Resolution
800 x 600
1024 x 768
1280 x 720
1280 x 768
1280 x 1024
1600 x 1200
1680 x 1050
1920 x 1080
1920 x 1200
Note: Resolution and refresh rates
The way you set the resolution and refresh rate differs, depending on the type of operating system
you have. Check your computer's manual or help topics for the appropriate steps.
Polycom, Inc.
.
Refresh rates (Hz)
56, 60, 72, 75, 85
60, 70, 75, 85
50, 60
60
60, 75
60
60
60
60
.
28