Table of Contents
Advertisement
5.7.21 Advanced settings
The special parameters cannot be viewed directly since they are normally only set and stored once. The
machine control offers the following special functions:
5.7.21.1 Selecting, changing and saving parameters
0
1
ENTER (Enter the menu)
•
Switch off machine at the main switch.
•
Press and hold the "left parameter selection" button and switch the machine on again at the
same time.
NAVIGATION (Navigate in the menu)
•
Parameters are selected by turning the "welding parameter setting" rotary dial.
•
Set or change the parameters by turning the "arc length correction/select welding program"
rotary dial.
EXIT (Exit the menu)
•
Press the "right parameter selection" button (settings will be applied, machine changes to
the ready-to-operate status).
099-005183-EW501
17.12.2010
0
A M P
1
HOLD
m /m in
Figure 5-38
NOTE
Design and function
MIG/MAG welding
VOLT
PROG
m /m in
67
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Phoenix 335 Progress Puls FA KGE and is the answer not in the manual?