Mounting The Drum Cleaning Blade; Mounting The Developing Blade; Replacing The Potential Sensor/Potential Control Pcb - Canon iR5000 Service Manual

CHAPTER 3 STANDARDS AND ADJUSTMENTS
3. Image Formation System
3.1 Routing the Grid Wire of the Primary Charging Assembly
See the Printer Manual: Chap. 4>7.8 "Charging Wire"
3.2 Routing the Charging Wire of Charging Assemblies
See the Printer Unit: Chap. 4>7.8 "Charging Wire"

3.3 Mounting the Drum Cleaning Blade

See the Printer Manual: Chap. 4>7.11 "Drum Cleaner"

3.4 Mounting the Developing Blade

See the Printer Manual: Chap. 4>7.8 "Developing Assembly"

3.5 Replacing the Potential Sensor/Potential Control PCB

See the Printer Unit: Chap. 4>7.4 "Potential Sensor Assembly"
1. The potential sensor and the potential control PCB are adjusted as a
single unit; be sure to replace both at the same time.
2. If you have replaced the sensor and the PCB, be sure to execute offset
adjustment of the sensor.
3-8 T
Download Free Service Manual at http://printer1.blogspot.com
COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000