Setting Up Lines
UDP
When you configure
will use to send UDP data to or receive UDP data from. For example:
The UDP configuration window, taken from the DeviceManager, is configured to:
UDP Entry 1
All hosts that have an IP address that falls within the range of
and listen to
only receive UDP data from the hosts in that range with a source
UDP Entry 2
All UDP data received from hosts that have an IP address that falls within the range of
172.16.1.20
Terminal Server will not send any data received on its serial port.
UDP Entry 3
All hosts that have an IP Address that falls within the range of
172.16.1.80
UDP data will be sent to the serial device.
UDP Entry 4
This entry is disabled since
If
Direction
Address and Port number based on the first UDP packet it receives and will then only send
and/or accept UDP data from that host.
46
, you are setting up a range of IP addresses and a port number that you
UDP
will receive UDP data from the serial device. The serial device will
Port 33001
to
and
172.16.1.50
and who listen to
Direction
is set to
or
, and
In
Both
Port
Terminal Server User Guide
Port 33010
will be sent to the serial device. The
Port 33009
will receive UDP data from the serial device. No
is set to
None
.
is set to
(zero), the Terminal Server will learn a host IP
0
to
172.16.1.1
172.16.1.25
of
.
Port
33001
to
172.16.1.75
Need help?
Do you have a question about the Terminal Server and is the answer not in the manual?