Show Server
Description Shows the parameters set for the server.
User Level Admin, Normal
Syntax
Hardware Commands
Set Ethernet
Description Sets the serial line speed and duplex.
User Level Admin
Syntax
Options
Show Hardware
Description Shows the hardware settings/information.
User Level Normal, Admin
Syntax
COMredirect Baud Commands
Set COMredirect Remap-Baud
Description Sets the COMredirect baud remapping values.
User Level Admin
Syntax
Options
Show COMredirect
Description Shows the Terminal Server COMredirect remapping table.
User Level Normal, Admin
Syntax
show server
set ethernet speed-and-duplex
auto|10-half|10-full|100-half|100-full
auto|10-half|10-full|100-half|100-full
Define the ethernet connection speed at one of the following:
—automatically detects the ethernet interface speed and duplex
auto
10 Mbps Half Duplex
10 Mbps Full Duplex
100 Mbps Half Duplex
100 Mbps Full Duplex
show hardware
set comredirect remap-baud
50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|19200|
38400
50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|19200|
38400|57600|115200|230400|28800
50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|19200|38400
The configured baud rate of the COMredirect client.
50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|19200|38400|
57600|115200|230400|28800
The actual baud rate that runs between the Terminal Server and the connected
serial device.
show comredirect
Server Commands
Command Line Interface 87
Need help?
Do you have a question about the Terminal Server and is the answer not in the manual?