Set Line Interface - Black Box Terminal Server User Manual

Terminal server
Table of Contents

Advertisement

Set Line Interface

Description Configures line interface (hardware) parameters.
User Level Admin
Syntax
set line interface eia-232 [monitor-dcd on|off]
[monitor-dsr on|off] [flow none|soft|hard|both]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|
19200|38400|57600|115200|230400|28800]
set line interface eia-422 [flow none|soft|hard|both]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800]
set line interface eia-485 [tx-driver-control auto|rts]
[flow none|soft]
[duplex full|duplex half [echo-suppression on|off]]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800]
Options
eia-232 | eia422 | 485
Specifies the type of line that is being used with the Terminal Server. Select either
EIA-232, EIA-422, or EIA-485.
monitor-dcd
Specifies whether the RS-232 signal DCD (Data Carrier Detect) should be
monitored. This is used with modems or any other device that sends a DCD signal.
When it is monitored and the Terminal Server detects a DCD signal, the line service
is started. Default is
signals must be detected before the line service is started.
monitor-dsr
Specifies whether the RS-232 signal DSR (data set ready) should be monitored.
This is used with modems or any device that sends a DSR signal. When it is
monitored and the Terminal Server detects a DSR signal, the line service is started.
Default is
Off
be detected before the line service is started.
flow
Defines whether the data flow is handled by the software (
Both
, or
None
tx-driver-control
Used with a
Send), select this option. Otherwise, select
duplex
Specify whether the line is
or
Half Duplex
echo-suppression
This parameter applies only to
echoed to the user and transmitted across the serial ports. Some EIA-485
applications require local echo to be enabled in order to monitor the loopback data
to determine that line contention has occurred. If your application cannot handle
loopback data, echo suppression should be
.
Off
speed
Specifies the baud rate of the line; keep in mind that speed is affected by the length
of the cable.
. If both
Off
Monitor DCD
. If both
and
Monitor DCD
.
serial interface, if your application supports
EIA-485
Full Duplex
(communication in one direction at a time).
EIA-485 Half Duplex
and
are enabled, both
Monitor DSR
are enabled, both signals must
Monitor DSR
), hardware (
Soft
Auto
. Default is
Auto
(communication both ways at the same time)
mode. All characters will be
. The default is echo suppression
On
Command Line Interface 101
Line Commands
),
Hard
(Request To
RTS
.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Terminal Server and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents