Using Arp-Ping; Ipv6 Network - Black Box Terminal Server User Manual

Using ARP-Ping

You can use the ARP-Ping (Address Resolution Protocol) method to temporarily assign an IP
address and connect to your Terminal Server to assign a permanent IP address. To use
ARP-Ping to temporarily assign an IP address:
1. From a local UNIX/Linux host, type the following:
arp -s a.b.c.d aa:bb:cc:dd:ee:ff
On a Windows
arp -s a.b.c.d aa-bb-cc-dd-ee-ff
(where
and
back of the unit.
2. Whether you use UNIX or Windows
Here is a UNIX example of the sequence to use:
arp -s 192.168.209.8 00:80:d4:00:33:4e
ping 192.168.209.8
You are now ready to configure the Terminal Server. See
page 37

IPv6 Network

The Terminal Server has a factory default link local IPv6 address that takes the following format:
Terminal Server MAC Address: 00-80-D4-AB-CD-EF
Link Local Address: fe80::0280:D4ff:feAB:CDEF
The Terminal Server will also listen for IPv6 router advertisements to learn a global address. You
do not need to configure an IPv4 address for a Terminal Server residing in an IPv6 network.
You are now ready to configure the Terminal Server. See
page 37
®
98 or newer system, type the following:
is the IPv4 address you want to temporarily assign to the Terminal Server,
a.b.c.d
is the Ethernet (MAC) address of Terminal Server, found on the
aa:bb:cc:dd:ee:ff
for information on the different Terminal Server configuration methods.
for information on the different Terminal Server configuration methods.
®
, you are now ready to ping to the Terminal Server.
Chapter 3, Configuration Methods on
Chapter 3, Configuration Methods on
Setting an Initial IP Address
Installation 29