Configuring Line Access
Host IP
TCP Port
Configuring Line Access
Line Access
Configure the following options:
Line Access
Configuring Sessions
You can configure user
user connects to a host. Users who are
addition to using defined sessions. Users who are
predefined sessions.
Configure the following parameters:
Session
Auto
The following
None—No connection is configured for this session.
Telnet—For information on the Telnet configuration window, see
67.
Configuring the Default User
When you add new users to the Terminal Server, they will initially inherit any parameters set in
the
Default User
For information on the
70.
72
When the
User Service
address. If 255.255.255.255 is specified in the configuration, the user will be
prompted for an IP address or hostname. If no IP address is specified, the
Host IP value in the
0.0.0.0
.
When the
User Service
value will change based on the type of
known port numbers are used as the default values.
defines the read/write privileges that a user has while accessing a line.
Specifies the user access rights to each Terminal Server device line.
Options are:
Read/Write—Users are given read and write access to the line.
Read In—Users are given access to read only outbound data, data that
is going from the Terminal Server to the device.
to limit the access the user has to the network and the way the
Sessions
You can create up to four predefined sessions for each user. You can
specify the connection service and its settings for each session.
Specify whether or not the session(s) will start automatically when the user
logs into the Terminal Server.
connections are available:
Session
(the parameters can be changed on a per user basis).
configuration parameters, see
Default User
Terminal Server User Guide
is set to
or
Telnet
TCP_clear
configuration will be used. The default is
Default User
is
Telnet
, this is the target port number. The default
Service
or
can define
Level Normal
Admin
Level Restricted
, the target host IP
selected; the most common
, in
Free Sessions
or
Menu
can only access
Telnet Settings on page
Configuring Users on page
Need help?
Do you have a question about the Terminal Server and is the answer not in the manual?