Black Box Terminal Server User Manual page 71

Level
The access that a user is allowed:
Hotkey Prefix
The prefix that a user types to control the current session. The default value
is hex 01
(^b), etc.):
The
can use the
parameter is
Idle Timer
The amount of time, in seconds, that the
to close a connection because of inactivity. When the
because there has been no exchange of data within the specified time, the
Terminal Server will close the connection. The default value is
meaning that the
permanently). The maximum value is 4294967 seconds. The
Timer
sessions.
Session Timer
The amount of time, in seconds, that the
timer to forcibly close a user's session (connection). When the
Timer
value is
is open permanently, or until the user logs out). The maximum value is
4294967 seconds. The
Timer
Language
You can specify whether a user will use
language that appears in the Menu, CLI, or WebManager. The Terminal
Server supports one custom language that must be downloaded to the
Terminal Server; otherwise,
Service
The type of service that the user will use.
Admin—The admin level user has total access to the Terminal Server.
You can create more than one admin user account but we recommend
that you only have one. They can monitor and configure the Terminal
Server.
Normal—The Normal level user has limited access to the Terminal
Server. Limited CLI commands and Menu access are available with the
ability to configure the user's own configuration settings.
Restricted—The Restricted level user can only access predefined
sessions or access the Easy Port Access menu. Can only view or
monitor the Terminal Server using CLI commands to display
information about the Terminal Server.
Menu—The menu level user will only be able to access predefined
session or access the Easy Port Access menu. The Easy Port Access
allows the user to connect to the accessible line without disconnecting
their initial connection to the Terminal Server. Does not have any
access to CLI commands.
, which corresponds to
^a number —To switch from one session to another, press
the required session number. For example,
session 2. Pressing
^a 0
—Display the next session. The current session will remain active.
^a n
The lowest numbered active session will be displayed.
^a p —Display the previous session. The current session will remain
active. The highest numbered active session will be displayed.
^a m —To exit a session and return to the Terminal Server. You will be
returned to where you left off. The session will be left running.
—(Lowercase L) Locks the line until the user unlocks it. The user is
^a l
prompted for a password (any password, excluding spaces) and locks
the line. Next, the user must retype the password to unlock the line.
^r —When you switch from a session back to the Menu, the screen may
not be redrawn correctly. If this happens, use this command to redraw it
properly.
value overrides the
User Hotkey Prefix
Hotkey Prefix keys to lock a line only when the line
.
On
Idle Timer will not expire (the connection is open
will override the
Line Idle Timer
expires, the Terminal Server will end the connection. The default
(zero), meaning that the session timer will not expire (the session
0
User Session Timer
, with the exception of reverse Telnet sessions.
Customlang
Ctrl-a ( ^a ) (hex value 02 would be Ctrl-b
would switch you to
^a 2
will return you to the Terminal Server Menu.
Line Hotkey Prefix
will run. Use this timer
Idle Timer
Idle Timer
, with the exception of reverse Telnet
Session Timer
will override the
English or Customlang
defaults to English.
Using the DeviceManager 71
Configuring Users
^a and then
value. You
Lock
expires,
(zero),
0
User Idle
will run. Use this
Session
Line Session
as the