Table of Contents
Advertisement
HRM
Zilog
' . HRM
cleared.
A line may contain a reference to a
test
not
on
the
tape
due to alteration or corruption of the tape.
Any
such line will be skipped in execution.
The user
is
noti-
fied
of any such line or of any line containing a test that
would overwrite the disk or tape.
If
any
line
overwrites
the
disk,
the user must verify that this is acceptable be-
fore execution of the list begins.
If any lineprinter
con-
trol line will cause printed output, and the lineprinter in-
terface has not been identified during
the
session,
SADIE
prompts
for
the
interface
(Centronics or Data Products).
During execution, if any test would overwrite the tape,
the
test is loaded, but execution halts until the SADIE tape has
been replaced with a scratch tape.
A request to reload
the
SADIE tape is not generated until SADIE next attempts to re-
position the tape.
NOTE
When the SADIE tape is replaced, wait until it
is
FULLY REWOUND before responding with Y.
During execution, SADIE updates an error log whenever an er-
ror
is detected or a test lap is completed.
Detailed error
messages are logged in the cumulative error log.
When
exe-
cution
is
complete,
enter a <CR> to return to the COMMAND
LEVEL.
RUNNING A SINGLE TEST:
Any test can
be
selected
and
run
with
the TEST command, T.
The catalog of tests and control
statements is presented.
The selected one is displayed with
default
parameters
set
by
SADIE.
~he
default repetition
count, 1, or the parameters can be
modified.
When
satis-
fied,
enter
a
<CR> to change the test into a special one-
line test list, and begin its execution.
The list check and
verification
of
any
attempt to overwrite the disk or tape
are then performed just as in running a regular
test
list.
When the test is complete, enter a' <CR> to return to COMMAND
LEVEL.
To rerun a test previously chosen with the TEST command
use
the REPEAT command, R.
It is now possible to modify the ex-
isting repetition count or parameters before
executing
the
test.
DISPLAYING THE TEST LIST ERROR LOGS:
The
DISPLAY
command,
D, displays an error summary log generated by execution of a
test or test list.
This log contains a line for
each
line
of
the
test
list.
Each error log line contains the test
name, the number of times it was run, the number of hard and
5-48
Zilog
5-48
- Quick Links:
- System 8000 Cpu Board (Cpu)
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the System 8000 and is the answer not in the manual?
Questions and answers