Show Interfaces Switchport; Show Interfaces Switchport - Display Description - Edge-Core Direk Tronik 24/48-Port Management Manual

45
Interface Commands

show interfaces switchport

This command displays the administrative and operational status of the specified
interfaces.
Syntax
show interfaces switchport [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: Always 1)
- port - Port number. (Range: 1-24/48)
• port-channel channel-id (Range: 1-24)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 4.
Console#show interfaces switchport ethernet 1/4
Broadcast threshold:
LACP status:
Ingress rate limit:
Egress rate limit:
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for Untagged Traffic: 0
GVRP Status:
Allowed VLAN:
Forbidden VLAN:
802.1Q-tunnel Status:
802.1Q-tunnel Mode:
802.1Q-tunnel TPID:
Console#
Table 45-2 show interfaces switchport - display description
Field
Broadcast threshold
LACP status
Ingress/Egress rate limit
45-10
Enabled, 500 packets/second
Disabled
Disable, 1000M bits per second
Disable, 1000M bits per second
Hybrid
Disabled
All frames
19
Disabled
1(u),
Enable
Access
8100(Hex)
Description
Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 47-1).
Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 46-4).
Shows if rate limiting is enabled, and the current rate limit (page 49-1).
19(u),4093(t),