Table - Edge-Core Direk Tronik 24/48-Port Management Manual

26
Class of Service Configuration
Web – Click Priority, Default Port Priority or Default Trunk Priority. Modify the default
priority for any interface, then click Apply.
CLI – This example assigns a default priority of 5 to port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
Information of Eth 1/3
Broadcast threshold:
LACP status:
Ingress rate limit:
Egress rate limit:
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic: 5
GVRP status:
Allowed VLAN:
Forbidden VLAN:
802.1Q-tunnel Status:
802.1Q-tunnel Mode:
802.1Q-tunnel TPID:
Console#
26-2
Figure 26-1 Default Port Priority
Enabled, 500 packets/second
Disabled
Disable, 1000M bits per second
Disable, 1000M bits per second
Hybrid
Disabled
All frames
1
Disabled
1(u),
Enable
NORMAL
8100(Hex)
45-1
55-3
45-10