Using Dhcp/Bootp - Edge-Core Direk Tronik 24/48-Port Management Manual

Using DHCP/BOOTP

If your network provides DHCP/BOOTP services, you can configure the switch to be
dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the management
station is attached, set the IP Address Mode to DHCP or BOOTP. Click Apply to
save your changes. Then click Restart DHCP to immediately request a new
address. Note that the switch will also broadcast a request for IP configuration
settings on each power reset.
Note:
If you lose your management connection, make a console connection to the
switch
and enter "show ip interface" to determine the new
CLI – Specify the management interface, and set the IP address mode to DHCP or
BOOTP, and then enter the "ip dhcp restart" command.
Console#config
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart
Console#show ip interface
IP Address and Netmask:
Address Mode:
Console#
Renewing DCHP – DHCP may lease addresses to clients indefinitely or for a
specific period of time. If the address expires or the switch is moved to another
network segment, you will lose management access to the switch. In this case, you
can reboot the switch or submit a client request to restart DHCP service via the CLI.
Setting the Switch's IP Address (IP Version 4)
Figure 5-2 IPv4 Interface Configuration - DHCP
192.168.0.100 255.255.255.0 on VLAN 1,
DHCP
5
switch
address.
45-1
59-1
59-3
59-4
5-3