Replacing The Default Secure-Site Certificate; Https System Support - Edge-Core Direk Tronik 24/48-Port Management Manual

12
User Authentication
- The client and server generate session keys for encrypting and decrypting data.
• The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 5.x or above
and Netscape 6.2 or above.
• The following web browsers and operating systems currently support HTTPS:
Web Browser
Internet Explorer 5.0 or later
Netscape 6.2 or later
• To specify a secure-site certificate, see "Replacing the Default Secure-site
Certificate" on page 12-6.
Command Attributes
• HTTPS Status – Allows you to enable/disable the HTTPS server feature on the
switch. (Default: Enabled)
• Change HTTPS Port Number – Specifies the UDP port number used for HTTPS/
SSL connection to the switch's web interface. (Default: Port 443)
Web – Click Security, HTTPS Settings. Enable HTTPS and specify the port number,
then click Apply.
CLI – This example enables the HTTP secure server and modifies the port number.
Console(config)#ip http secure-server
Console(config)#ip http secure-port 441
Console(config)#

Replacing the Default Secure-site Certificate

When you log onto the web interface using HTTPS (for secure access), a Secure
Sockets Layer (SSL) certificate appears for the switch. By default, the certificate that
Netscape and Internet Explorer display will be associated with a warning that the
site is not recognized as a secure site. This is because the certificate has not been
signed by an approved certification authority. If you want this warning to be replaced
by a message confirming that the connection to the switch is secure, you must
12-6
Table 12-1 HTTPS System Support
Operating System
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Solaris 2.6
Figure 12-3 HTTPS Settings
41-12
41-13