Spanning-Tree Max-Age; Spanning-Tree Priority - Edge-Core Direk Tronik 24/48-Port Management Manual

spanning-tree max-age

This command configures the spanning tree bridge maximum age globally for this
switch. Use the no form to restore the default.
Syntax
spanning-tree max-age seconds
no spanning-tree max-age
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or [2 x (hello-time + 1)].
The maximum value is the lower of 40 or [2 x (forward-time - 1)].
Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure. All device
ports (except for designated ports) should receive configuration messages at
regular intervals. Any port that ages out STA information (provided in the last
configuration message) becomes the designated port for the attached LAN. If
it is a root port, a new root port is selected from among the device ports
attached to the network.
Example
Console(config)#spanning-tree max-age 40
Console(config)#
Related Commands
spanning-tree forward-time (51-3)
spanning-tree hello-time (51-4)

spanning-tree priority

This command configures the spanning tree priority globally for this switch. Use the
no form to restore the default.
Syntax
spanning-tree priority priority
no spanning-tree priority
priority - Priority of the bridge. (Range – 0-61440, in steps of 4096;
Options: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768,
36864, 40960, 45056, 49152, 53248, 57344, 61440)
spanning-tree max-age
51
51-5