Show Dot1Q-Tunnel; Displaying Vlan Information; Commands For Displaying Vlan Information - Edge-Core Direk Tronik 24/48-Port Management Manual

52
VLAN Commands

show dot1q-tunnel

This command displays information about QinQ tunnel ports.
Command Mode
Privileged Exec
Example
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#interface ethernet 1/2
Console(config-if)#switchport dot1q-tunnel mode uplink
Console(config-if)#end
Console#show dot1q-tunnel
Current double-tagged status of the system is Enabled
The dot1q-tunnel mode of the set interface 1/1 is Access mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/2 is Uplink mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/3 is Normal mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/4 is Normal mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/5 is Normal mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/6 is Normal mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/7 is Normal mode, TPID is 0x8100.
.
.
.
.
The dot1q-tunnel mode of the set interface 1/24 is Normal mode, TPID is 0x8100.
Console#
Related Commands
switchport dot1q-tunnel mode (52-14)

Displaying VLAN Information

This section describes commands used to display VLAN information.
Table 52-1 Commands for Displaying VLAN Information
Command
show vlan
show interfaces status vlan
show interfaces switchport
52-16
Function
Shows VLAN information
Displays status for the specified VLAN interface
Displays the administrative and operational status of an
interface
Mode Page
NE, PE 52-17
NE, PE 45-8
NE, PE 45-10