Reload; Switch Renumber - Edge-Core Direk Tronik 24/48-Port Management Manual

34
System Management Commands

reload

This command restarts the system.
Note:
When the system is restarted, it will always run the Power-On Self-Test. It will also
retain all configuration information stored in non-volatile memory by the copy
running-config startup-config command.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command resets the entire system.
Example
This example shows how to reset the switch:
Console#reload
System will be restarted, continue <y/n>? y

switch renumber

This command resets the switch unit identification numbers in the stack. All stack
members are numbered sequentially starting from the top unit for a non-loop stack,
or starting from the Master unit for a looped stack.
Note:
This switch does not support stacking.
Syntax
switch all renumber
Default Setting
• For non-loop stacking, the top unit is unit 1.
• For loop stacking, the master unit is unit 1.
Command Mode
Global Configuration
Example
This example shows how to renumber all units.
Console#switch all renumber
Console#
34-2