Enabling Qinq Tunneling On The Switch - Edge-Core Direk Tronik 24/48-Port Management Manual

23
VLAN Configuration

Enabling QinQ Tunneling on the Switch

The switch can be configured to operate in normal VLAN mode or IEEE 802.1Q
(QinQ) tunneling mode which is used for passing Layer 2 traffic across a service
provider's metropolitan area network.
Command Attributes
802.1Q Tunnel – Sets the switch to QinQ mode, and allows the QinQ tunnel port to
be configured. The default is for the switch to function in normal mode.
Web – Click VLAN, 802.1Q VLAN, 802.1Q Tunnel Status. Check the Enabled box
and click Apply.
CLI – This example sets the switch to operate in QinQ mode.
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#exit
Console#show dot1q-tunnel
Current double-tagged status of the system is Enabled
The dot1q-tunnel mode of the set interface 1/1 is Access mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/2 is Uplink mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/3 is Normal mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/4 is Normal mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/5 is Normal mode, TPID is 0x8100.
.
.
.
The dot1q-tunnel mode of the set interface 1/24 is Normal mode, TPID is 0x8100.
Console#
23-16
Figure 23-1 802.1Q Tunnel Status
52-14
52-16