Configuring Snmpv3 Management Access - Edge-Core Direk Tronik 24/48-Port Management Manual

11
Simple Network Management Protocol
Web – Click SNMP, Configuration. Enter the IP address and community string for
each management station that will receive trap messages, specify the UDP port,
SNMP trap version, trap security level (for v3 clients), trap inform settings (for v2c/v3
clients), and then click Add. Select the trap types required using the check boxes for
Authentication and Link-up/down traps, and then click Apply.
CLI – This example adds a trap manager and enables authentication traps.
Console(config)#snmp-server host 10.1.19.23 private version 2c
udp-port 162
Console(config)#snmp-server enable traps authentication

Configuring SNMPv3 Management Access

To configure SNMPv3 management access to the switch, follow these steps:
1. If you want to change the default engine ID, do so before configuring other
SNMP parameters.
2. Specify read and write access views for the switch MIB tree.
3. Configure SNMP user groups with the required security model (i.e., SNMP v1,
v2c or v3) and security level (i.e., authentication and privacy).
4. Assign SNMP users to groups, along with their specific authentication and
privacy passwords.
11-6
Figure 11-3 Configuring SNMP Trap Managers
40-5
40-7