Reset/Restart Screen - ZyXEL Communications WAP5605 User Manual

The following table describes the labels in this screen.
Table 43 Maintenance > Backup/Restore
LABEL
Backup
File Path
Browse...
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default WAP5605
IP address. See
computer's IP address.

11.8 Reset/Restart Screen

System restart allows you to reboot the WAP5605 without turning the power off.
Click Maintenance > Reset/Restart to open the following screen.
Figure 63 Maintenance > Reset/Restart
Click Restart to have the WAP5605 reboot. This does not affect the WAP5605's configuration.
WAP5605 User's Guide
DESCRIPTION
Click Backup to save the WAP5605's current configuration to your computer.
Type in the location of the file you want to upload in this field or click Browse... to find it.
Click Browse... to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Click Upload to begin the upload process.
Note: Do not turn off the WAP5605 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the WAP5605 again. The WAP5605 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the WAP5605 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
WAP5605. Refer to the chapter about introducing the Web Configurator for more information
on the RESET button.
Appendix C on page 135 for details on how to set up your
Chapter 11 Maintenance
99